Assembly
1. Unpack and remove the whole unit from packaging.
2. Fit the Lower Handle onto the Main Unit, ensuring the handle faces
forward.
The clips on the Lower Handle push into the hole in pivot joint on the Main Unit.
This will require some force to
push together
3. Push the handle tubes and the upper Handle firmly together.
Note the telescopic tube is at the top, and the tube with the smallest end fitting
should be at the bottom
Press the tubes against a non-marking floor to ensure they are
fully together.
Then push the assembled tubes into the lower handle.
Before first use charge the battery for 20 hours
Ensure the tube with
the smallest end
fitting is at the bottom
Telescopic tube
Getting Started
To Next Page
Loading...
