To Next PageTo Next Page
Need help?Do you have a question about the Guardall V12 Pet Friendly and is the answer not in the manual?
General| Brand | Guardall |
|---|---|
| Model | V12 Pet Friendly |
| Category | Security System |
| Language | English |
Diagram showing the side view coverage of the Pet Friendly V12 detector.
Indicates the area within which pets are tolerated by the detector.
Specifies the operating voltage range for the detector.
Details the current consumption in alarm and non-alarm states.
Specifies the maximum allowable ripple on the power supply.
Describes the horizontal coverage adjustment.
Explains how the LED is used for indication.
Specifies the operational temperature limits.
Details how the detector compensates for temperature changes.
Specifies the normally closed alarm output contact.
Specifies the duration of the alarm output signal.
Specifies the normally closed tamper output contact.
Describes how to use the test input for activation.
Guidelines for avoiding common false alarm triggers like sunlight or drafts.
Steps for preparing the detector, removing the cover, and selecting mounting.
Instructions for running cables and connecting wires to the PCB terminal block.
Enabling Pulse Count reduces false alarms by requiring two detections.
Adjusting PIR gain to decrease detection range from 10x10m to 7x7m.
Procedure to verify detector coverage, including LED enable and walk testing.
Detector performs self-tests; failure indicated by dim LED.
Monitors supply voltage; low voltage causes LED to flash.
Details LED behavior for low voltage, alarm, and self-test failures.
Guides on issues like no LED indication, flashing LED, dim LED, and continuous PIR activity.
Information on product warranty against defects in workmanship and materials.
Masks lower beams and declines remaining beams to allow pets to move freely.
Advice on moving the lens towards position A if pets on furniture cause alarms.
