Gude TK 2400 ECO - User Manual

Questions and Answers

V
victoriamillsAug 11, 2025
What to do if my Gude TK 2400 ECO Saw motor shuts off during work?
- Z
  zacharywhiteAug 11, 2025
  If your Gude Saw motor shuts off during operation, it could be due to a few reasons. One possibility is a defective thermal sensor, which would require replacement by a qualified electrician. Another reason may be the motor circuit breaker. Also, the saw might be switching off due to overloading. In the latter two cases, allow the motor to cool down for 5-10 minutes before restarting.
J
Jessica RobinsonAug 18, 2025
Why is my Gude TK 2400 ECO overloading?
- S
  Scott Johnson MDAug 18, 2025
  Overloading in your Gude Saw can stem from several causes. Firstly, the supply line might be too long or have an inadequate cross-section. Ensure the extension cable is appropriately dimensioned (1.5 mm2). Secondly, the saw disc may not be sharp enough, in which case you should sharpen it. Lastly, an incorrect chamfer on the saw disc teeth could be the culprit; have it corrected by a professional.
A
Aaron FreemanAug 26, 2025
How to troubleshoot a Gude TK 2400 ECO Saw motor that will not run?
- D
  Danielle HuntAug 27, 2025
  If your Gude Saw motor won't run, there are a couple of things to check. First, ensure the unit is receiving power. Inspect the supply and power line, and if needed, consult a qualified electrician. Second, the thermal sensor might have interrupted the power supply. If this is the case, wait 5-10 minutes and try switching it on again.
M
megan63Sep 2, 2025
What to do if Gude Saw leaves scorch traces?
- J
  Jason DeleonSep 2, 2025
  Scorch marks on the material you're cutting with your Gude Saw are likely due to a blunt saw disc. You should sharpen or replace the saw disc.