Guildline 6675A - 7.1.2. 6675 A Warnings

Section 7
7-2
7.1.2. 6675A Warnings.
Corrective measures : Enter prompted or missing variable.
WARNING 6675A OPERATING MODE
Reversal Rate too low or not set!! Minimum reversal rate is 4
seconds!!
<Main_Setup_Edit>
Rs value has not been set!! <Main_Setup_Edit>
R0 or Rtpw value has not been set!! <Main_Setup_Probes_Edit_Mode_
Probe>
Extender Ratio not set <Main_Setup_Resistor_Edit_
Mode_Iextend>
Test Value not set
Max Test Value has not been set
Test Value EXCEEDS Max Test Value
Test Value Exceeds Maximum Current Output!! Test Value
set to _ _ _ _
Max Current Output (250 mA)!!!
Test Value is below minimum current output (1mA)!!!
Maximum Current Value exceeds Maximum Current output
(250mA)!!!
Test Value Exceeds Maximum Voltage output!!!
Test Value set to _ _ _ _
Maximum Voltage Output (990V)!!!
Test Value is below minimum Voltage output (15.8V)!!!
Setting DAC C or DAC D may magnetize the core!!!!
Set Internal Values.
This menu allows full control of 6675A. Great care should
be taken when using these functions.
Self test not completed
Operation cancelled.
Table 7-2 : 6675A Warnings