EasyManua.ls Logo

Gunnebo SpeedStile BP DS Wide Lane User Manual

Gunnebo SpeedStile BP DS Wide Lane
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
S PEEDS TILE BP
DS
series
Operation & Maintenance Manual

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Gunnebo SpeedStile BP DS Wide Lane and is the answer not in the manual?

Gunnebo SpeedStile BP DS Wide Lane Specifications

General IconGeneral
CategorySecurity System
TypeOptical Turnstile
MaterialStainless Steel
Operating Temperature0°C to +50°C
Detection TechnologyInfrared Sensors
ThroughputUp to 40 passages per minute
IntegrationAccess Control Systems

Summary

Introduction to SpeedStile BP DS

Product Description

Operating Modes

Configuration modes for transit direction (Unlock, Lock, Reader Control).

Passage Management Logic

Logic managing passage, detection, and signals.

Method of Operation

How the system responds to access signals and presence.

Instructions For Use

Basic Operation Guide

Step-by-step guide for normal passage operation.

Emergency and Fire Alarm

How the system reacts to emergency signals.

Power Failure Management

System behavior during power loss and battery backup.

Safety Precautions for Users

Important safety notes and warnings for users.

Programmable Parameters Overview

Overview of parameters affecting system operation.

Technical Information

MB01 Board Setup and Trimmers

Setup, maintenance, and trimmer configuration for the MB01 board.

Access Control and Validation

Controlled access, reader interface, validation, and priority logic.

Installation Guide

Setting to Work and Alignment

Final setup, mechanism alignment, and casework adjustments.

Maintenance Procedures

Component Replacement Procedures

Steps for replacing PCBs, photocells, and batteries.

Fault Finding and Troubleshooting

Guide to diagnose and resolve system faults.

Spare Parts Information

Appendix A – Wiring Schematics

MB01 Trimmers Factory Setting

Default factory settings for MB01 trimmers.

GC01 Jumpers Factory Setting

Default factory settings for GC01 board jumpers.

Commissioning Checklist

Step-by-step guide for initial system commissioning.

Firmware Upload Procedure

Instructions for uploading firmware to the control boards.

Related product manuals