Guyson 2 - Machine Settings; Blast Settings

Operation &
Maintenance
Manual
Issue:
10
A6ML0066 – Euroblast SF Instruction Manual
Date:
05/2019
Page: 21
5. Machine settings
5.1 Blast settings
The blast settings should be set in the order they appear in the following sections.
5.1.1 Blasting pressure
Air pressure controls the speed at which the blast media leaves the nozzle. Blasting speed increases
at higher pressures and shortens operation time. Never use a higher blast pressure than necessary to
achieve the finish required.
 Higher pressure air is less economical
 It may distort or damage components
 Greater media breakdown means higher media consumption
 Noise increases
Adjust the blast gun pressure
using the control knob on the main
air inlet filter. The gauge shows the
set pressure.