REMOTE CONTROL
123
4. Press the Up/Down key to
select ON or OFF.
5. Press the Enter key followed by
the Exit key. The USB setting is
stored and the display goes back
to the default display.
6. Connect the USB cable to the
rear panel terminal (upper port).
C
A
L
K
E
Y
Insert GPIB Card
Power Off
Turn the Power Off and take out the power cord.
Open the
GDM-8261
optional
communication
port
Take off the two screws on the slot corners to remove
the optional communication port cover. Keep the screws
for later reuse.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
