REMOTE CONTROL
125
2. Press the Down key and the
Left key. The GPIB selection
display appears.
Note: The GPIB menu will be
selectable only when the GPIB
card is installed.
3. Press the Down key. The GPIB
ON/OFF selection appears.
4. Press the Up/Down key to
select ON or OFF.
5. To continue to the GPIB
address configuration, press the
Enter key. The GPIB address
configuration menu appears.
1st display
Shows the GPIB address.
2nd display
Indicates GPIB address setting
6. Change the address using the
Left/Right and Up/Down keys.
Range 0~30 (Default = 15)
7. Press the Enter key followed by
the Exit key. The GPIB setting
is stored and the display goes
back to the default display.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
