REMOTE CONTROL
129
5. Press the Enter key followed by
the Exit key. The EOL setting is
stored and the display goes back
to the default display.
Set the Separation Character
Description
The TX TERM configuration menu can set the
separation character for remote commands.
Configuration
1. Press the Shift key, the 2nd
(Menu) key, the left key
repeatedly until the TX TERM
configuration menu appears.
2ND
MENU
2. Press the Down key and then
the Right key. The SEP selection
display appears.
3. Press the Down key. The SEP
selection menu appears.
4. Press the Up/Down key to
select the separation character.
(CR+LF/LF/CR)
5. Press the Enter key followed by
the Exit key. The SEP setting is
stored and the display goes back
to the default display.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
