SCANNER (OPTIONAL)
99
Select Channel Group and Enable Scanner
Background
16 channels are available for the scanner when using the
GDM-8261.
Group1
CH101 ~ 118
Select group
(Jumper J8)
Set the jumper J8 in the center of the board to the
MASTER configuration. Move the jumper to the right
(pins 2-3) to select CH1xx (101 ~ 118). The GDM-8261
does not support the SLAVE operation mode with the
optional scanner.
1 2 3
J8
1
2
3
1
2
3
CH201-218
SLAVE
CH101-118
MASTER
Enable scanner
(Jumper J9)
Set the jumper J9 on the rear side of the board
accordingly. Move the jumper up (pins 3-2) to disable the
scanner, and down (pins 2-1) to enable the scanner.
3
2
1
J9
3
2
1
3
2
1
Enabled
Disabled
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
