GW Instek GDM-8261A - Page 115

SCANNER (OPTIONAL)
115
3. Press the Down key again. The
Starting (Minimum) channel
setting appears.
4. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
HOLD TRIG
Range
101 ~ 118
5. When finished, press the Enter
key. The End (Maximum)
channel setting appears.
AUTO
ENTER
6. Move the cursor to the channel
using the Left/Right key, and
change the value using the
Up/Down key.
HOLD TRIG
Range
101 ~ 118, (must be equal to or greater
than the Start (Min) channel)
7. When finished, press the Enter
key. The Timer setting appears.
AUTO
ENTER
8. Move the cursor to the time
setting using the Left/Right key,
and change the value using the
Up/Down key.
HOLD TRIG
Range
1ms ~ 9999ms
www. .com
information@itm.com1.800.561.8187