GW Instek GDM-8351 - Power up

GDM-8351 User Manual
24
Power Up
Steps
1. Ensure the correct line
voltage is lined up with
the arrow on the fuse
holder. If not, see page 141
to set the line voltage and
fuse.
2. Connect the power
cord to the AC
voltage input.
Note
Make sure the ground connector on the power
cord is connected to a safety ground. This will
influence the measurement accuracy.
3. Push to turn on the main
power switch on the front
panel.
4. The display turns on and shows the last
function that was used before the power was
reset.
P
O
W
E
R