REMOTE CONTROL
215
Set the USB Protocol
The USB device port on the rear panel is used for remote
control. The USB port can be configured as either a
TMC or CDC interface.
Before the GDM-9060/9061 can be used for remote
control utilizing the CDC or TMC USB class, install the
appropriate CDC or TMC USB driver included on the
User Manual CD.
USBCDC:
The USB port on the GDM-9060/9061 will appear as a
virtual COM port to a connected PC.
USBTMC:
The GDM-9060/9061 can be controlled using National
Instruments NI-Visa software*. NI-Visa supports USB
TMC.
*To use the TMC interface National Instruments
Measurement and Automation Explorer can be used.
This program is available on the NI website,
www.ni.com., via a search for the VISA Run-time Engine
page, or “downloads” at the following URL,
http://www.ni.com/visa/
Configure RS232 Interface
115200/57600/38400/19200/9600
1. Press the Menu key, and then
the Page Down key repeatedly
until the Interface configuration
menu appears.
w ww. . com
information@itm.com1.800.561.8187
To Next Page
Loading...
