GW Instek GDM-9060 - AC;DC Current Measurement

BASIC MEASUREMENT
37
AC/DC Current Measurement
Background
The GDM-9061, with front/rear input terminals, has two
input terminals for current measurement: the 3A terminal
for current less than 3A and a 10A terminal for
measurements up to 10A, which can measure between 3
~ 10A for both AC and DC current. On the other hand,
for the GDM-9060, which has no rear input terminals,
nor 10A terminal, it offers merely a 3A terminal for
current measurement less than 3A.
Current type
GDM-9060
AC/DC 3A
GDM-9061
AC/DC 3A/10A
Activate ACI/ DCI
Measure
Press the Shift → ACV or Shift →
DCV key to measure AC or DC
current, respectively.
+
or
ACI/DCI mode
display appears
The measurement will switch to ACI, DCI mode
immediately. See the figure below for example.
AC or DC Current
Indicates DC or AC Current mode
5/s
Indicates the active refresh rate
Indicates Automatic range selection
Range: 100mA
Indicates the available range of Current
000.03 mAAC
Indicates the exact measured value
w ww. . com
information@itm.com1.800.561.8187