GDS-806/810/820/840 Programming Manual
70
:WMEMory<X>:OFFSet
After the “:WMEMory<X>:LOCate” command is specified, you can adjust the
position up or down by this command.
Syntax
:WMEMory<X>:OFFSet <NR1>
Arguments
<X>→Specify the location of RefA or RefB memory (1|2)
<NR1> is the desired offset position. The rage is from –100 to +100.
:WMEMory<X>:SAVe
Select whether the memory set will be saved.
Syntax
:WMEMory<X>:SAVe <1|2|3>
Arguments
<X>→Specify the location of RefA or RefB memory (1|2)
1→Channel 1
2→Channel 2
3→Math function
To Next Page
Loading...
