SECTION
1
GENERAL DESCRIPTION
INTRODUCTION
The DIGITAL FUNCTION GENERATOR provides square, triangle,
sine, ramp and pulse waveforms over a frequency range from
0.2
Hz
to
2
MHz,
plus a VCF input, variable DC offset and TTL or
CNOS
pulse output.
The built-in frequency counter for measuring internal
oscillation frequency.
FRONT PANEL
The main output and all controls are located on the front
panel. They are: the push button POWER switch, seven frequency
RANGE push button switches, three push button FUNCTION switches,
frequency MULTIPLIER (variable), DUTY potentiometer with invert
switch, DC OFFSET control with level control, output
AMPLITUDE
control with output attenuation, OUTPUT,VCF (voltage controlled
frequency) input, TTL or CMOS pulse output, CMOS level control
with CMO,C/TTL selector SW, counter display,
M.k.m.
and
Hz
indicato~,
Gate signal indicator.
REAR PANEL
On
the rear panel is located the power cord receptacle.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
