FUNCTION GENERATOR-SERIES
INSTRUCTION MANUAL
35
2).Pull apart the handle from the Function Generator. Please turn the
handle left and right side slightly, that will make easier to pull off the
handle.
3).There are two washers inside of two holes (the joints of handle and case)
respectively. Please use a screwdriver to pry open these washers.
FUNCTION GENERATOR-SERIES
INSTRUCTION MANUAL
36
4).Please use a screwdriver to open the screw located at upper side of rear
panel. Therefore, the upper cover can pull toward the backside. In the
meantime, the upper cover is moved.
Note: If you want to install the upper cover, please reverse above steps.
7-3. Cleaning
To keep the instrument clean, wipe the case with a damp cloth and
detergent. Do not use abrasives or solvents.
www. .com
information@itm.com1.800.561.8187
To Previous Page
Loading...
