GW Instek LCR-1100 - Command Specifiers Explanation

COMMAND OVERVIEW
55
A complete sending instruction package (PC side) is as follows:
cSize: 0x0000003C,
sHeader: IDN?
sPara: (empty)
nSignature: 0x88805550
nChecksum: 0x00002BC1
Since the format and number of digits of the sending command
packet are fixed, the command word and parameters must be filled
with hexadecimal HEX: 0x00 if the number of bytes is less than the
specified number. For example, the Hex format of a complete
sending packet is as follows:
Table
A command
to send
packet data
The packet size of the instrument response is also 64
bytes, which is not enough to fill with 0x00 (Note: not
the ASCII number 0).
A received packet (instrument side) is as follows:
ASCII format: GwINSTEK,LCR-1100,0,REV A1.0
Specifiers
When describing the directive, we use some specifiers, these
specifiers are not part of the directive, just for the convenience of
explanation, please don't include it when passing the directive.
Table
Specifiers
Specifier
Description
< >
Angle brackets denote parameter
names
[ ]
Square brackets indicate that the
content is optional
|
Indicates multiple choice