GW Instek LCR-1100 - System Lock and Hold Commands

LCR-1000 Series
66
CORR:SHORT:DCR
Function： It executes DCR short circuit correction.
Description：
Set syntax CORR:SHORT:DCR
Return data <pass|fail>
Note
 “DCR short” is prompted when the correction
starts
 Prompt “pass or fail” after correction
SYST:KEYL <ON | OFF | 1 | 0>
Function： It locks or unlocks the keypad and touch screen.
Description：
Set parameter <ON | OFF | 1 | 0>
Set syntax SYST:KEYL
Note
 When the keys and touch screen are locked,
the user can press the LOCAL [
] key to
unlock!
 The power button and key tone still work.
SYST:HOLD <ON | OFF | 1 | 0>
Function： It holds or releases the current screen data.
Description：
Set parameter <ON | OFF | 1 | 0>
Set syntax SYST:HOLD
Note
 When the measured value is held, a red
symbol
DH will be displayed on the upper
right corner of the screen.
 This command is valid only on the "MEAS
DISPLAY" page.