LCR-8000 Series User Manual
108
Setting fail reset
Using the AUTO mode for part testing saves time and accuracy, but
sometimes the measurement results are wrong due to poor contact!
You can use the FAIL RETEST function to re-measure when the
contact is poor, so as to avoid the problem.
1. Press the Measure button to enter
[MEAS DISPLAY] page, and press the
LIST SET function button on the right
side of the LCD to enter the [LIST SET]
page, and then press the Setup button
to enter [LIST MODE SETUP] page.
2. Use arrow keys to move cursor and
select FAIL RESET item on the [LIST
MODE SETUP] page.
3. Use option key on the right of the LCD screen to
select a desired item.
Fail retest function turn off
Re-measure only when SETP1 is bad
Re-measurement
every time a step is bad
To Next Page
Loading...
