CORRECTION (OPEN/SHORT)
131
Setting cable length
When using a wired test fixture, set the length according to the line
length to compensate when OPEN/SHOT correction.
1. Press the Measure button to enter
[MEAS DISPLAY] page, and then
press the CORR. function button on
the right side of the LCD to enter the
[CORRECTION] page.
2. Use arrow keys to move cursor and
select CABLE LENGTH item on the
[CORRECTION] page.
3. Use option key on the right of the LCD screen
to select the line length item.
If the FIXTURE COMPENSATION item is
selected, CABLE LENGTH item will not be able to
make selections.
To Next Page
Loading...
