GW Instek LCR Series - Setting Load Function

To Next Page

To Previous Page

CORRECTION (OPEN/SHORT)

135

Setting load function

SPOT LOAD needs to set the real and imaginary values of the test

part measurement parameters to obtain the correct phase angle and

other calculation data.

Steps

1. Press the Measure button to enter

[MEAS DISPLAY] page, and then

press the CORR. function button on

the right side of the LCD to enter the

[CORRECTION] page.

2. Use arrow keys to move cursor and

select LOAD FUNCTION item on the

[CORRECTION] page.

3. Use option key on the right of the LCD screen

to select ↑or↓ item switch function.

Other manuals for GW Instek LCR Series