GW Instek LCR Series - Measure:speed; Measure:beeper {OFF|PASS|OK|FAIL|NG|0|1|2]; Measure:beeper; Measure:voltage:ac <Voltage Nr3;Disc

LCR-8000 Series User Manual
182
:MEASure:FREQuency MINimum
Query syntax
:MEASure:FREQuency?
Return data 1.000000E+03 (Format is in <NR3>)
:MEASure:SPEEd
{MAXimum|FAST|MEDium|SLOW|SLOW2|0|1|2|3|4}
:MEASure:SPEEd?
Function： It sets or queries the SPEED.
Description：
Set parameter MAXimum/0, FAST/1, MEDium/2,
SLOW/3,SLOW2/4
Set syntax
:MEASure:SPEEd
1
:MEASure:SPEEd FAST
Query syntax
:MEASure:SPEEd?
Return data FAST (Format is in <disc>)
:MEASure:BEEPer {OFF|PASS|OK|FAIL|NG|0|1|2]
:MEASure:BEEPer?
Function： It sets or queries the BEEP WHEN.
Description：
Set parameter
OFF, PASS|OK, FAIL|NG
Set syntax
:MEASure:BEEPer PASS
:MEASure:BEEPer NG
:MEASure:BEEPer OFF
Query syntax
:MEASure:BEEPer?
Return data PASS| FAIL| OFF
:MEASure:VOLTage:AC <voltage NR3/disc>
:MEASure:VOLTage:AC?
Function： It sets or queries the AC measurement voltage (LEVEL).
Description：
Set parameter When RO (output impedance) is setting 100
Ω
, the
setup value of AC voltage is {
0.01~2|MAXimum|MINimum}. When