GW Instek LCR Series - Sweep:delay <Delay Timenr3;Disc; Sweep:delay; Sweep:oimpedance {100|25; Sweep:oimpedance

LCR-8000 Series User Manual
212
:SWEep:DELay <delay timeNR3/disc>
:SWEep:DELay?
Function： It sets or queries the sweep delay between measurement
points.
Description：
Set parameter The value of delay time is
{0.0~5|MAXimum|MINimum}.
Set syntax
:SWEep:DELay 0.5
:SWEep:DELay 500M
:SWEep:DELay 500MS
:SWEep:DELay 5E-3
:SWEep:DELay MAXimum
:SWEep:DELayMINimum
Query syntax
:SWEep:DELay?
Return
data 0.500 (Format is in <NR2>)
:SWEep:OIMPedance {100|25}
:SWEep:OIMPedance?
Function： It sets or queries the output impedance of sweep mode.
Description：
Query syntax
:SWEep:OIMPedance?
Return data 100|25 (Format is in <NR1>)
:SWEep:KEEP {OFF|ON|0|1}
:SWEep:KEEP?
Function： It sets or queries the KEEP PREVIOUS TRACE.
Description：
Set syntax
:SWEep:KEEP ON
:SWEep:KEEP 0
Query syntax
:SWEep:KEEP?
Return
data ON | OFF (Format is in <disc>)