GW Instek LCR Series - Setting X-axis

SWEEP (GRAPH MODE)
63
Setting X-axis
The X-axis scale shows 2 modes LINEAR and LOG.
Steps
1. Press the Measure button to enter
[MEAS DISPLAY] page, and then
press the SWEEP function button on
the right side of the LCD to enter the
[SWEEP DISPLAY] page.
2. Use arrow keys to move cursor and
select X-AXIS item on the [SWEEP
DISPLAY] page.
3. Use option key on the right of the LCD screen
to select a parameter for this sweep item.
Available
parameter
LINEAR
The starting value to the ending value,
equal to 251 points
LOG
The starting value to the ending value,
use the logarithm to distinguish 267
points (maximum). Different points
depending on the status of the range
setting
AUTO
FIT
Automatically adjust the Y-axis scale
and position of the sweep graph