GW Instek PEL-2002 - Page 164

PEL-2000 Series User Manual
164
6. Use the selector knob to turn
ON, OFF or CLEAR the OCP
Setting.
7. Repeat steps 1-5 for :
OVP Level
OVP Setting
OPP Level
OPP Setting
UVP Level
UVP Setting
Clearing an Alarm
When any of the protection settings are tripped, Alarm
will be shown on the Mainframe Status Panel and an
alarm tone will sound by default.
8. Turn the load off by pressing the
Load key and turn off the load
input.
ON /
OFF
LOAD
9. Change the XXP Setting to Clear
to clear the alarm.
Note
See pages 59 and 239 to output alarms via the
Go/NoGo output terminal.
The configuration settings only apply to the current
channel.