GW Instek PEL-3111 - Page 144

PEL-3000(H) User Manual
142
sequence.
 Every-time Insert Point is pressed the Step
parameter is incremented.
 The newly inserted “point” becomes the active
step.
3. Set the following parameters for the currently
selected step. See page 135 for configuration
details.
 Value
 TRIG OUT
4. If you wish to edit a previously added
point/step, use the Steps parameter.
 Steps can only be selected after they have
already been added.
Steps
0001 - 1000(RPTSTEP)
5. The currently selected step can be deleted using
the Delete Point[F2] function.
 There cannot be less than 3 steps for fast
sequences.
Fill Function
6. Press FILL[F4] to use the fill function. Set the fill
parameters:
 Start_Value
 End_Value
 Start_Step
 End_Step
The fill function can be used any number of times.
Save
7. After all the steps for the sequence are
complete, press Save[F3] to save the steps.
Data Edit for Fast Sequences configuration is
complete.