GW Instek PEL-3111 - Auto Load Configuration

OPERATION
77
Auto Load Configuration
Description
The PEL-3000(H) can be configured to
automatically load the last program, normal
sequence, fast sequence or load setting at startup.
By default, this setting is disabled.
Operation
1. Press
Shift
+
Utility
Help
> Load[F2].
2. Turn Auto Load On or Off.
 When set to OFF, the Auto Load setting is
disabled.
3. Select the Auto Load On configuration.
 This will select whether the PEL-3000(H) will
automatically load the last program, normal
sequence, fast sequence or load settings.
Auto Load On:
Load, Prog, NSeq, FSeq