Appendix
71
Appendix
Specifications
The specifications apply under the following conditions: PSH is
powered on for at least 30 minutes, within +20°C~+30°C.
Common specification
Recovery Time CV mode ≤ 2ms (50% step load change from
25%~75%)
Voltage Up ≤ 150ms (10%~90% ≤ 95% rating
load)
Response Time
Voltage Down ≤ 150ms (90%~10% ≥ 10% rating
load)
Voltage (mVrms) ≤ 10mVrms,100mVpp,20Hz~20MHz Ripple & Noise
Current (mArms) ≤ 0.2% + 40mA
Temperature
Coefficient
Voltage
(25±5°C)
≤ 100ppm/ °C
Protection Over Voltage Protection, Over Current Protection, Over
Heat Protection, Inrush Current Protection
Output On/Off Available
AC Power Input 100~230V, 50/ 60 Hz
Location Indoor
Altitude ≤ 2000m
Ambient
temperature
Specification: 10°C~35°C (50°F~95°F)
Operation: 0°C~40°C (32°F~104°F)
Relative
Humidity
85% RH (maximum), non condensing
Installation Category II (for details, see page6)
Operation
Condition
Pollution Degree 2 (for details, see page8)
Storage
Condition
−10°C~70°C, 70% RH (maximum)
Accessories User manual, Programming manual, Cable gland, AC
power cord, AC input cover, O/P terminal cover
PSH User Manual
72
PSH-1036A/ 2018A/ 3610A/ 6006A
Output PSH-1036A 10V, 36A
PSH-2018A 20V, 18A
PSH-3610A 36V, 10A
PSH-6006A 60V, 6A
Load ≤ 0.1% + 5mV
Regulation
(C.V.) Line ≤ 0.05% + 5mV
Load ≤ 0.2% + 5mA
Regulation
(C.C.)
Line ≤ 0.2% + 5mA
Voltage (mVrms) ≤ 10mVrms, 100mVpp,
20Hz~20MHz
Ripple & Noise
Current (mArms) ≤ 0.2%
Voltage ≤ 0.05% + 25mV (rating ≤ 36V)
≤ 0.05% + 50mV (rating > 36V)
OVP ≤ 0.1% + 50mV (rating ≤ 36V)
≤ 0.1% + 100mV (rating > 36V)
Program
Accuracy
Current ≤ 0.2% + 30mA
Voltage & OVP 10mV (rating ≤ 36V)
20mV (rating > 36V)
Program
Resolution
Current 10mA
Voltage ≤ 0.05% + 25mV (rating ≤ 36V)
≤ 0.05% + 50mV (rating > 36V)
Readback
(Meter)
Accuracy Current ≤ 0.2% + 30mA
Voltage 10mV (rating ≤ 36V)
20mV (rating > 36V)
Readback
(Meter)
Resolution
Current 10mA
Fuse 6.3A/ 250V AC x 2
Dimensions 108 x 141 x 388 mm
Weight Approx. 3.3kg
To Next Page
Loading...
