GW Instek PSW 30-72 - Interface Configuration; USB Remote Interface; Configure GPIB Interface

PSW Series User Manual
142
Interface Configuration
USB Remote Interface
USB
configuration
PC side
connector
Type A, host
PSW side
connector
Rear panel Type B, slave
Speed
1.1/2.0 (full speed/high speed)
USB Class
CDC (communications device
class)
Steps
1. Connect the USB cable to the rear
panel USB B port.
2. Change the Rear panel-USB (F-22)
setting to USB-CDC (2).
Page 115
Configure GPIB Interface
To use GPIB, the optional GPIB to USB (GUG-001) adapter must be
used. Only one GPIB address can be used at a time.
Configure GPIB
1. Ensure the PSW is off before proceeding.
2. Connect the USB cable from the rear panel
USB B port on the PSW to the USB A port on
the GPIB to USB adapter.
3. Connect a GPIB cable from a GPIB controller to
the GPIB port on the adapter.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com