GW Instek PSW 30-72 - Run Test Script (Manual)

PSW Series User Manual
92
Run Test Script (Manual)
Overview
A test script can be run from one of ten memory
slots.
Steps
1. Before a test script can be run, it
must first be loaded into one of the
10 memory save slots.
Page 90
2. Configure T-01 (Run Test) to 1~10
(save memory slot#)
Page 89
T-01 range
1~10
3. The loading screen will appear. For example if
memory slot #1 is loaded, the following screen
will appear.
Note
If the script is very small, the loading screen may
not appear on the screen for very long.
When the “t00X Load” screen is shown on the
display, pushing the TEST key will abort the loading
procedure.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com