OPERATION
95
Export Test Script to USB
The Export Test function saves a test file to the
root directory of a USB flash drive.
Files will be saved as tXXX.tst where XXX is
the memory number 001~010 from which
the test script was exported from.
Files of the same name on the USB flash
drive will be written over.
1. Insert a USB flash drive into the
front panel USB-A slot.
2. Turn on the power. MS (Mass Storage) will be
displayed on the screen after a few seconds if
the USB drive is recognized.
If the USB drive is not recognized, check to see
that the function settings for F-20 = 1 (page 110). If
not, reinsert the USB flash drive.
3. Configure T-03 (Test Export) to
0~10 (save memory slot)
4. The script will now be copied to the USB flash
drive.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
