gwm ORA GOODCAT 2022 - How to Use the Three-Point Seat Belt

The force limiter can maintain seat belt
load at an acceptable level and reduce
force exerted on the passenger's chest.
Working conditions
The pretensioner seat belt works when
the vehicle receives a signicant impact
from the front.
It may not function when the following
minor collisions occur.
〉
When the vehicle hits a concrete wall
square at a speed below 25km/h.
〉
When the vehicle collides with an ob-
ject with a small surface area, such as
a xed electrical pole or tree, at a
speed lower than 35 km/h.
The pretensioner seat belt may not fully
function when the vehicle is subjected to
the following severe collision.
〉
The vehicle ips over by 90° or 180°.
〉
In the event of a collision from the side
or from the rear.
WARNING
〉
When using the pretensioner seat
belt, please adjust the seat to the op-
timal driving position. Failure to do
so will undermine seat belt perform-
ance, leading to an increased risk of
severe bodily injury and death.
〉
If you wish to install, remove or dis-
mantle the pretensioner seat belt, be
sure to contact service provider. If
the pretensioner seat belt is not used
correctly, it will not function as
normal. It may cause severe injury or
even death in an accident.
〉
The pretensioner seat belt cannot be
deployed repeatedly.
After the pretensioner has been de-
ployed during the rst collision, you
should not extend or retract the seat
belt again when the second and sub-
sequent collisions occur. Be sure to
contact service provider for replace-
ment.
〉
When the pretensioner seat belt is
deployed, there may be loud sounds
and white smoke emanating from
the device. This will not lead to a re
or cause harm to the human body.
〉
When a pretensioner seat belt needs
to be replaced and disposed of,
please contact service provider. Inad-
vertent/accidental movements of the
pretensioner seat belt can cause
harm to the human body.
How to use the three-
point seat belt
1. Hold the locking tab and pull the seat
belt out of the retractor. Make sure
that you do not twist the seat belt in
the process. If you are unable to pull
the seat belt out of the retractor, you
will need to rst pull hard at the seat
belt and then release it. Doing so will
trigger the retractor and allow you to
pull out the seat belt smoothly.
210
4
Safety