EasyManua.ls Logo

gwm ORA GOODCAT 2022 - Page 223

Default Icon
277 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2. Adjust or remove the headrest from
the seat where the child seat is to be
installed.
NOTICE
For a rear-mounted child seat, adjust
the headrest to the lowest position
or remove it.
For a front-mounted child seat, re-
move the headrest if it aects the t-
ting of the child seat back and the
rear seat back.
If a raised seat cushion is used, it is
forbidden to remove the headrest,
and the top of the headrest should
be adjusted to a position that is ush
with or closest to the top of the
child's head.
3. Slide the child seat locking mecha-
nism into the lower xing point to en-
sure that the two ISOFIX locking
mechanisms are properly xed.
4. Fasten the top tether strap at its cor-
responding xing point. Don't curl
over the top tether strap. When se-
curing, you must make sure that the
top tether strap passes through the
bottom of the seat headrest.
5. Shake the child seat gently to make
sure that it has been properly se-
cured.
Use the seat belt to install the
child seat
1. Move the front seat as far forwards
as possible.
2. Adjust or remove the headrest from
the seat where the child seat is to be
installed.
NOTICE
For a rear-mounted child seat, adjust
the headrest to the lowest position
or remove it.
For a front-mounted child seat, re-
move the headrest if it aects the t-
ting of the child seat back and the
rear seat back.
If a raised seat cushion is used, it is
forbidden to remove the headrest,
and the top of the headrest should
be adjusted to a position that is ush
with or closest to the top of the
child's head.
3. Pull out the shoulder belt, run the
belt along the indicated route on the
child seat and insert the lock pin into
the buckle until you hear a "click"
sound.
4. With your body weight pressing
down on the child seat, allow the
shoulder belt to retract and tighten.
There must be no signs of slack to
the shoulder belt.
5. If the child seat is not equipped with
a seat belt attachment, you can pur-
chase a locking clip to secure the
seat belt.
6. Shake the child seat gently to make
sure that it has been properly se-
cured.
222
4
Safety

Table of Contents