insucient tyre pressure levels.
NOTICE
The tyre pressure in normal tyres can
go down by 10 to 20 kPa every month.
Please check regularly.
Tyre wear
FF3563DBE361
Ⓐ Tyre wear mark
Ⓑ Tyre wear mark position gure
NOTICE
Tyre wear mark position gure is a
schematic diagram, which is used for
reference only. Please refer to the ac-
tual vehicle.
You must replace tyres as soon as possi-
ble once they have been worn down to
the maximum tolerable limit.
If you continue to use tyres with shallow
treads or where the tyre wear mark has
appeared, it will lead to situations such
as longer braking distances, diculties
in steering and cracked tyres and possi-
bly accidents as a result.
If you nd tyre wear uneven, or feel a
certain continuous vibration when driv-
ing, go to a service provider.
When installing new tyres, tyre balancing
must be performed to ensure ride com-
fort and to prolong tyre use life.
Tyre rotation
In order to extend the life of the tyre
and make tyre wear even, it is recom-
mended that the tyres of the rear and
front wheels should be exchanged on a
regular basis.
The tyre rotation should be done by the
professionals and it is recommended to
be done by a service provider.
Wheel balance
Unbalanced wheels can aect vehicle
manipulation performance and tyre life.
Even under the normal use conditions,
the wheels may lose their balance.
Therefore, the wheels should be bal-
anced according to the wheel balancing
parameters.
Avoid tyre atness
If the vehicle is parked in a high temper-
ature environment for an extended peri-
od of time, a slight deformation of the
tyre in the contact position with the
ground may occur, which is called "Tyre
atness", which is normal. However,
when the vehicle is running, the vehicle
body and steering wheel may shake. As
the mileage increases, the tyre will get
hot and return to its original shape, and
260
6
Maintenance
To Next Page
Loading...