Delay function
Within a few seconds after turning the
power supply to LOCK mode, the sun-
roof and sunshade still can be operated.
Speedy closing
With the the power supply in LOCK
mode and all the doors and back door
closed, press and hold the lock button
on the key or the lock sensor on the
door handle to automatically close the
sunroof.
Automatic sunroof closing
〉
With the the power supply in LOCK
mode, if the rainfall and light sensor
perceives rain and snow, the sunroof
will be closed automatically.
NOTICE
In case of a little rain, the sunroof may
not be closed automatically. Therefore
it is suggested that you ensure the sun-
roof is completely closed before leav-
ing the vehicle.
〉
The sunroof will close automatically if
the vehicle speed exceeds 120 km/h in
the driving.
Initialization
If the system is in disorder, it can be re-
covered through the following opera-
tions:
1. Close the sunroof and sunshade
completely, press and hold the sun-
roof button until the sunroof and the
sunshade jitter and then release the
button.
2. Press and hold the sunroof button
again within 5 seconds until the sun-
roof and sunshade complete the
movement from being open to full
closed, then release the button, and
the initialization is complete.
If the sunroof rebounds during the clos-
ing process, it can be forced to initialize
through the following operations:
1. When the sunroof rebounds, press
and hold the sunroof button immedi-
ately, and continue to keep pressing
and holding the sunroof button after
the rebound is over, until the sunroof
is completely closed and jitters once,
and then release the button.
2. Press and hold the sunroof button
again within 5 seconds until the sun-
roof completes the movement from
being open to fully closed, then re-
lease the button, and the sunroof ini-
tialization is completed.
If the sunshade rebounds during the
closing process, it can be forced to initi-
alize through the following operations:
1. First close the sunroof completely.
2. Then close the sunshade, and if it re-
bounds, immediately press and hold
the sunshade button. After the re-
bound, continue to keep pressing
and holding the sunshade button un-
til the sunshade is completely closed
and jitters once, and then release the
35
1
Operation
To Next Page
Loading...