Vehicle equipment
Please note that this manual contains all
the standard equipment, country-specif-
ic equipment and special equipment for
this model series. Thus, some equip-
ment or features described in this man-
ual may not be installed onto your vehi-
cle or are only available in some mar-
kets. For further conguration informa-
tion, please refer to relevant sales infor-
mation or consult with your distributor
selling the vehicle to you.
Lamp settings
NOTICE
The layout and operation of multime-
dia display screen may vary from the
model congurations, please refer to
the actual vehicle.
Through the multimedia display screen,
the following light settings can be car-
ried out :
〉
Touch 【Active welcome setting】 but-
ton, and the active courtesy setting
can be activated or deactivated.
After activating this function, when the
power is in LOCK mode or the position
lamp is o, unlock the vehicle door
from the outside, and the daytime
running lamp and the position lamp
on the back door will be lightened dy-
namically.
〉
Tap the 【Power saving delay time】
setting button to set the delay
eective time of the power saving
function.
After the ignition switch is turned to
the LOCK position, if the state of the
power supply of the vehicle, the door
lock or the emergency ashers switch
don’t change within the set time, the
power saving function will be activated
automatically to save power.
〉
Tap the
【Ceiling lamp delay time】
button to set the delay time for the in-
terior lamps to go out after all doors
are closed when the interior lamps are
on due to the door control function.
〉
Tap the 【Take me home delay】 but-
ton to set the continuous lighting time
of the position lamp and the low beam
headlamp after the "Follow-me-home"
function is triggered.
〉
Tap the 【Vehicle search function
mode】 setting button to set the vehi-
cle prompt status when the vehicle lo-
cating function is triggered.
Light control combination
switch
Main lighting switch
3927AC98287D
Light control
56
1
Operation
To Next Page
Loading...