〉
Turn the main lamp knob to the width
lamp position
to turn on the posi-
tion lamp and the license plate lamp.
CAUTION
Do not use the position lamp to re-
place the low beam headlamp in the
driving. Otherwise, there is a risk of an
accident.
The position lamps are not bright
enough to illuminate the road in front
of the vehicle or allow other vehicles
and pedestrians to see the vehicle.
Therefore, turn on the low beam head-
lamp when the weather is dim or visi-
bility is poor.
〉
Turn the main lamp knob to the low
beam headlamp position
to turn on
the low beam headlamp and keep the
position lamp and the license plate
lamp illuminated.
〉
Turn the knob of the main lamp knob
to the AUTO position. The width lamps
and low beam headlamps will be
turned on or o automatically accord-
ing to the brightness of the surround-
ing environment.
CAUTION
〉
When visibility is aected in the day
due to fog, the lamps may not light
up automatically. Please turn on the
lamps manually in this case.
〉
Automatic light control can only as-
sist the driver. At all times the driver
should be responsible for the lighting
of the vehicle.
〉
Turn the main lamp knob to the OFF
position to turn o all vehicle lamps.
Fog lamp switch
DD2CEF12CC39
When the low beam headlamp is illumi-
nated, turn the fog lamp knob to the
rear fog lamp position
repeatedly to
turn the rear fog lamp on or o. When
released, the knob will automatically re-
turn.
Turn signal and lane change sig-
nal
DB397E53DFCA
Ⓐ Lane change signal
Ⓑ Turn signal
〉
Lane change signal: Pull up or push
57
1
Operation
To Next Page
Loading...