gwm ORA GOODCAT 2022 - Emergency Flashers; Daytime Running Lamp

down the light control combination
switch gently and release it, then the
light control combination switch will
return automatically and the corre-
sponding turn signal lamp will ash 3
times.
〉
Turn signal: Pull up or push down the
light control combination switch and
release it, then the light control combi-
nation switch will not return automati-
cally and the corresponding turn sig-
nal lamp will ash continuously.
High/low beam manual switch
44B9EE7AB515
Ⓐ High beam headlamp on
Ⓑ High beam headlamp ashes
〉
When the low beam headlamp is on,
press the light control combination
switch in a direction away from the
steering wheel to turn on or o the
high beam headlamp; when you re-
lease the light control combination
switch, it returns automatically.
〉
The high beam headlamp turns on
when you pull the light control combi-
nation switch up in a direction close to
the steering wheel; when released, the
light control combination switch auto-
matically returns and the high beam
headlamp goes out. You can repeat
this operation to make high beam
headlamp ash.
Emergency ashers
9A856D1FB2AE
In the event of vehicle failure or trac
accident, turn on the emergency ash-
ers to warn other vehicles.
Press the switch to turn on or turn o
the emergency ashers.
Daytime running lamp
To allow other drivers to see your vehi-
cle more clearly, the daytime running
lamps automatically light up when the
vehicle is started.
The daytime running lamps will go out
when the following conditions are trig-
gered:
〉
When the headlamps lamp is turned
on.
〉
When the left or right turn signal lamp
is on, the daytime running lamp on the
same side will turn o.
58
1
Operation