User Manual
H3C S1526 Smart Ethernet Switch Chapter 4
Typical Configuration
4-2
z Enable port trunking on port 25 and port 26 to increase
the bandwidth.
z Connect a computer to the S5000P to manage the
S1526. Note that the port to which the management
computer is connected should be in VLAN 1 (default
management VLAN).
Note:
z You can also use other gigabit switch as the uplink switch of
the S1526, provided this uplink switch should support port
trunking.
z Make sure to configure the port of the uplink switch to which
the S1526 is connected in VLAN 1.
z You need to enable port trunking on the ports of the S5000P
connected with the S1526.
To Next Page
Loading...
