H3C S3100 8C SI User Manual

Operation Manual – MSTP
H3C S3100 Series Ethernet Switches Chapter 1 MSTP Configuration
1-19
Operation Description Related section
Configure the mode a port
recognizes and sends
MSTP packets
Optional
Section
1.3.5
“Configuring the Mode a
Port Recognizes and
Sends MSTP Packets
”
Configure the MSTP
operation mode
Optional
Section
1.3.6
“Configuring the MSTP
Operation Mode
”
Configure the maximum
hop count of an MST
region
Optional
Section
1.3.7
“Configuring the
Maximum Hop Count of
an MST Region
”
Configure the network
diameter of the switched
network
Optional
The default value is
recommended.
Section
1.3.8
“Configuring the Network
Diameter of the Switched
Network
”
Configure the MSTP
time-related parameters
Optional
The default values are
recommended.
Section
1.3.9
“Configuring the MSTP
Time-related Parameters
”
Configure the timeout
time factor
Optional
Section
1.3.10
“Configuring the Timeout
Time Factor
”
Configure the maximum
transmitting speed of the
port
Optional
The default value is
recommended.
Section
1.3.11
“Configuring the
Maximum Transmitting
Speed on the Current
Port
”
Configure the current port
as an edge port
Optional
Section
1.3.12
“Configuring the Current
Port as an Edge Port
”
Specify whether the link
connected to a port is a
point-to-point link
Optional
Section
1.3.13
“Specifying Whether the
Link Connected to a Port
Is Point-to-point Link
”
 Note:
In a network containing switches with both GVRP and MSTP enabled, GVRP packets
are forwarded along the CIST. If you want to advertise packets of a specific VLAN
through GVRP, be sure to map the VLAN to the CIST when configuring the MSTP
VLAN mapping table (the CIST of a network is spanning tree instance 0).

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English