H3C S3100 8C SI - Page 853

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-7
Operation Command Description
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP
address is configured.
Configure the number of
probes per test
count times
Optional
By default, each test
makes one probe.
Configure the packet size
datasize size
Optional
By default, the packet size
is 56 bytes.
Configure the maximum
number of history records
that can be saved
history-records number
Optional
By default, the maximum
number is 50.
Configure the automatic
test interval
frequency interval
Optional
By default, the automatic
test interval is zero
seconds, indicating no
automatic test will be
made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times
out in three seconds.
Configure the type of
service (ToS)
tos value
Optional
By default, the service
type is zero.
Start the test
test-enable
Required
Display test results
display hwping results
[ admin-name
operation-tag ]
Required
Available in any view.
 Note:
For a HWPing ICMP test, if no IP address is configured for the source interface
configured through the source-interface command, the test cannot be performed; if a
source IP address has already been configured through the source-ip command, the
source-interface command does not take effect.
2) Configuring DHCP test on HWPing client