H3C S3100 8C SI - Page 862

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-16
Operation Command Description
Configure the source IP
address
source-ip ip-address
Optional
By default, the source IP
address is not specified.
Configure the source port
source-port port-number
Optional
By default, no source port
is specified.
Configure the number of
probes per test
count times
Optional
By default, one probe is
made per time.
Configure the automatic
test interval
frequency interval
Optional
By default, the automatic
test interval is zero
seconds, indicating no
automatic test will be
made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times
out in three seconds.
Configure the maximum
number of history records
that can be saved
history-records number
Optional
By default, the maximum
number is 50.
Configure the type of
service
tos value
Optional
By default, the service
type is zero.
Start the test
test-enable
Required
Display test results
display hwping results
[ admin-name
operation-tag ]
Required
The display command
can be executed in any
view.
8) Configuring UDP test on HWPing client
Table 1-12 Configure UDP test on HWPing client
Operation Command Description
Enter system view
system-view
—
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing
client function is disabled.
Create a HWPing test
group and enter its view
hwping
administrator-name
operation- tag
Required
By default, no test group
is configured.