6
Figure 6 12LFF front panel
(1) VGA connector (optional) (2) USB 2.0 connector (optional)
(3) Diagnostic panel (optional for the 8LFF SAS/SATA+4LFF NVMe drive configuration)
(4) USB 3.0 connector
(5) Diagnostic panel (optional for the 12LFF SAS/SATA drive configuration)
(6) SAS/SATA or NVMe drives (7) SAS/SATA drives
LEDs and buttons
The LED and buttons are the same on all server models. Figure 7 shows the front panel LEDs and
buttons. Table 3 descri
bes the status of the front panel LEDs.
Figure 7 Front panel LEDs and buttons
(1) Health LED (2) mLOM Ethernet adapter Ethernet port LED
(3) Power on/standby button and system power LED (4) UID button LED
Table 3 LEDs and buttons on the front panel
Button/LED Status
Health LED
• Steady green—The system is operating correctly.
• Flashing green (4 Hz)—HDM is initializing.
• Flashing amber (0.5 Hz)—A predictive alarm has occurred.
• Flashing amber (1 Hz)—A general alarm has occurred.
• Flashing red (1 Hz)—A severe alarm has occurred.
To Next Page
Loading...
