7
Button/LED Status
If a system alarm is present, log in to HDM to obtain more information about
the system running status.
mLOM Ethernet adapter
Ethernet port LED
• Steady green—A link is present on the port.
• Flashing green (1 Hz)—The port is receiving or sending data.
• Off—No link is present on the port.
Power on/standby button
and system power LED
• Steady green—The system has started.
• Flashing green (1 Hz)—The system is starting.
• Steady amber—The system is in Standby state.
• Off—No power is present. Possible reasons:
{ No power source is connected.
{ No power supplies are present.
{ The installed power supplies are faulty.
{ The system power cords are not connected correctly.
UID button LED
• Steady blue—UID LED is activated. The UID LED can be activated by
using the following methods:
{ Press the UID button LED.
{ Activate the UID LED from HDM.
• Flashing blue:
{ 1 Hz—The firmware is being upgraded or the system is being
managed from HDM.
{ 4 Hz—HDM is restarting. To restart HDM, press the UID button LED
for eight seconds.
• Off—UID LED is not activated.
Ports
The server does not provide fixed USB 2.0 or VGA connectors on its front panel. However, you can
install a front media module if a USB 2.0 or VGA connection is needed, as shown in Table 4. For
detailed p
ort locations, see "Front panel view."
Table 4
Optional ports on the front panel
Port Type Description
USB connector USB 3.0/2.0
Connects the following devices:
• USB flash drive.
• USB keyboard or mouse.
• USB optical drive for operating system
installation.
VGA connector DB-15
Connects a display terminal, such as a monitor or
KVM device.
Rear panel
Rear panel view
Figure 8 shows the rear panel view.
To Next Page
Loading...
