SECTION 6, continued
71
6.4.2 Printer Setup Commands
6.4.2.1 Printer Speed Selection
The 2100AN Turbidimeter can be configured for fast or slow (2.5 second delay)
print speed.
1. Enter the setup mode by pressing
SETUP. The small LED mode display
will flash.
2. Select the number
01 using the up, down and right arrow (edit) keys.
3. Press the
ENTER key to activate the print speed selection mode. Use the up or
down arrow keys to select the flashing
FAST PRT for fast or SLOW PRT for
slow print speed.
4. Press the
ENTER key to accept the desired setting.
5. Press
SETUP to exit the setup mode. Pressing UNITS/EXIT at any time, prior to
accepting the new print speed setting, exits the printer setup mode leaving
original settings intact.
6.4.2.2 Printer Output Selection
1. Enter the setup mode by pressing
SETUP. The small LED mode display
will flash.
2. Select the number
02 using the edit keys. Press the ENTER keytogointothe
printer setup mode.
3. Toggle through the
INT (the built-in printer), EXT (the RS232 connection), or
BOTH printer outputs using the edit keys. Press the ENTER keytoselectthe
desired output.
4. Press
SETUP to exit the setup mode. Pressing UNITS/EXIT at any time, prior to
accepting the new output setting, exits the printer setup mode leaving original
settings intact.
6.4.2.3 Print Interval Setting
1. Enter the printer setup mode by pressing
SETUP. The small LED mode display
will flash.
2. Select the number
03 using the edit keys followed by ENTER. MM-SS IVL is
displayed with the left digit flashing.
3. Set the minutes and seconds (
MM-SS) for the automatic print interval time
using the edit keys (
00-15 to 99-99). To disable the print interval setting, select
00-00. Press ENTER to accept the new setting.
4. Press
SETUP to exit the setup mode. Pressing UNITS/EXIT at any time, prior to
accepting the new value, exits the setup mode leaving original values intact.
To Next Page
Loading...
