Page 94 Bottle Mode – PAT700 Total Organic Carbon Analyzer
Operator Manual Anatel
WGM - 28 November 2007 - Edition 01
• Back icon takes you to the bottle mode dialog box.
• Forward icon takes you to the grab sample setup dialog box.
• Cancel icon returns you to the previous dialog box. All changes made in any of the
dialog boxes are lost.
5) Close the bottle bay door.
6) Touch the forward icon. The enter bottle information dialog box appears and allows
you to enter information about the grab sample.
7) After entering the appropriate information about the grab sample, touch the forward
icon. The grab sample setup dialog box appears. See Figure 6-20.
Figure 6-20 Grab sample setup dialog box
• Reps text box allows you to specify the number of repetitions to perform on the
sample bottle. You may enter a value from 1 to 3. The default setting is 3.
• Bottle ID text box allows you to specify an identifier to be used in the data buffer
and in reports. You may specify a 4-digit number. The default setting is 0.
• Return to online mode after analysis check box allows you to return to the home
screen after the test is complete.
• Schedule icon takes you to the schedule test dialog box. See Figure 6-8. All
changes made in this dialog box are retained.
• Run now button takes you to the run grab sample dialog box. See Figure 6-21. All
changes made in this dialog box are retained.
• Cancel icon takes you to the unload/replace bottles dialog box. All changes made
in any of the dialog boxes are lost.
To Next Page
Loading...
