Page 68 Setup – PAT700 Total Organic Carbon Analyzer
Operator Manual Anatel
WGM - 28 November 2007 - Edition 01
Return to online mode checkbox tells the analyzer whether or not to return to online mode
following the calibration. You may enable or disable (default) this option. When enabled, the
analyzer returns to online mode following the calibration. When disabled, the analyzer stays
at the bottle mode dialog box. All valves are closed, the pump is off, and the lamp is off.
Slope limit from previous cal text box allows you to specify the acceptable percent
difference between the resulting gain factor and the current value. You may enter a value from
1 to 5%. The default value is 5%.
Slope limit from factory cal text box allows you to specify the acceptable percent
difference between the resulting gain factor and the factory value. You may enter a value from
1 to 10%. The default value is 10%.
Use calibration resistor check box allows the use of the calibration check resistor during
the conductivity calibration process. See Conductivity calibration, page 85.
Return icon returns you to the setup dialog box and saves any changes. Any changes are
noted in the audit trail.
TOC validation tab
Figure 5-22 Bottle test setup dialog box, TOC validation tab
Return to online mode checkbox enables the analyzer to return to the online mode
following the validation. You may enable or disable (default) this option. When enabled, the
analyzer returns to online mode following the validation. When disabled, the analyzer stays at
the bottle mode dialog box. All valves are closed, the pump is off, and the lamp is off.
Return icon returns you to the setup dialog box and saves any changes. Any changes are
noted in the audit trail.
To Next Page
Loading...
