Page 132
Diagnostics
CAUTION
Potential puncture hazard! Contact with the exposed needle could cause serious
injury. Use extreme care when installing and removing the sample bottles.
CAUTION
Potential burst hazard! Do not exceed the maximum 100 psi (690k Pa) sample
pressure ratings.
1. After you’ve selected the bottles to load, install the grab samples bottles following the
instructions as shown in the load bottles dialog box (Figure 110) and ensuring that
you place the bottles in the correct positions.
2. Close the bottle bay door.
• Bottle positions graphics show you the order in which to install the bottles.
Figure 109 Select bottles to load dialog box, plumbing test
Figure 110 Load bottles dialog box, plumbing test
To Next Page
Loading...
