Page 16
Installation
2.2.2 Mounting to a wall
Follow these guidelines and refer to Figure 2, Figure 3 and Figure 4 to mount the
transmitter to a wall or other flat, rigid surface:
• Use 5/16-inch (8 mm) diameter screws or bolts and nuts to mount the analyzer to a
wall or other flat, rigid surface. Use hardware that can withstand the process
environment. HACH Company does not supply these screws, bolts, or nuts.
• To minimize stress on the analyzer mounting bracket, secure all mounting bolts to the
same structure, which should be flat and should not vibrate or move excessively. Do
not secure bolts to separate girders, beams, or wall studs that can move
independently.
Figure 4 PAT700 wall mount
To Next Page
Loading...
